RamCharger.net

I am looking to lift my truck 3-6" not sure on exactly what i can afford or what will work best and be the simplest. Just looking for some advice on where to get the parts what parts and how high i can go without really exploding the cost.

1999 Ram 2500 V10 5 speed 4x4

I am thinking the cheepest thing would be a set of front coil springs and some blocks in the back. However the truck already has a stock block with overloads in the back. Not sure of the exact size of everything. And i cant get measurements as im on the other side of the world.

So any tips or places to look for a good price would be greatly appreciated.

So i have gas mixing with my oil all of a sudden in my ramchargers 318?

Okay, well here goes.
Loki is my 1975 Dodge Ram-Charger
Its got a 318-727-np203 part time kit, dana 44's with locking hubs.
When I got the truck it had a massive list of issues and I had to learn as I went along. With a lot of failures and dumb moves and plenty of help from people on RCC I learned and little by little got most of my issues resolved. I rewired it twice replaced the ignition system a few times as well as put in a brand new edelbrock intake and carb. I fixed the lift did a crappy paint job and broke just about everything else including my brake lines and bleeder valves. I replaced the whole fuel system and made a custom pickup for the tank. All and all two and a half years later I am almost done. I could never get that edelbrock carb to work right tried everything under the sun adjusted the floats installed bigger metering rods/jets but it just cant feed that 318 the right amount of fuel/air and mostly fuel.