RamCharger.net

Help => Vehicle Help => Topic started by: underdogrow on August 28, 2015, 12:53:15 AM

Title: Short tailshaft 727
Post by: underdogrow on August 28, 2015, 12:53:15 AM
I'm swapping a 318 for 360, problem lies with the trans crossmember, drive shaft,  and differential.   From what I've read this particular 727 has a bolt on yoke won't allow enough play between the transmission and differential.   The truck is a long bed.   Do I need a two piece drive shaft?  Can I install a slip yoke without a costly trip to the transmission shop?

Sent from my SCH-S968C using Tapatalk

Title: Re: Short tailshaft 727
Post by: ProjectPW on August 28, 2015, 07:17:13 AM
yes you will likely need a 2 piece driveshaft with a carrier bearing. You will have to take a measurement and call a driveshaft shop to know for sure though  :thumbsup:

If you need to change the transmission to a slip yoke output the transmission should be rebuilt and modified with the correct tailhousing and output shaft by a reputable transmission repair shop  :great:
Title: Re: Short tailshaft 727
Post by: rjtx667 on August 28, 2015, 10:23:43 AM
Maybe I am a step behind here.. but why would swapping the 318 to the 360 out cause an issue with where the transmission lines up?

I have done this before and its not been a problem.
Title: Re: Short tailshaft 727
Post by: taz_man440 on September 25, 2015, 10:19:32 AM
Only difference should be just the counterweight on the torque converter right??
Title: Re: Short tailshaft 727
Post by: bullboy0852 on October 14, 2015, 07:56:32 AM
If you do have any issues I've got a 727 on the 2wd with a 360, trannys shot but could be it has the shaft and tail piece and correct crossmember, if there's a difference

Sent from my XT1526 using Tapatalk