I am tired of the gas pedal on my 76 RC. i was wondering what i would need to do to put a suspended gas pedal in. any info would be great.
I would think you need the petal and cable. maybe have to figure out a mount for the petal but not sure. I can look when I get home and take some pics for you if needed.
I have installed several. You can get one from almost any vehicle but might have to fabricate a cable the right length. I think you will have to fab something to hold the end of the cable at the carb too, but most likely you can get one that will work off of a newer truck.
Also, might have to cut a square hole in the firewall to plug in the firewall end of the cable housing. I drill a hole and use an air powered sheet metal saw or a jig saw to square out the corners. Might need a small file to finish.
I have a pedel that mounts to the firewall with 2 bolts and and the cable to the carb for a mid 80s truck.
i dont see why you cant drill a hole for the cable and the 2 bolt holes to mount it in the early cabs.
the cable hooks into the arm and has a plastic pin to lock it into the groove, then a round or square plastic piece that pops/locks into the firewall hole.
PM me if you want it, you can have it, it is from the junk cab i am replacing.