dana 44 front axle shafts needed.

[ernestgonzales78@gmail.com]

Ok I know this is a dodge formum. I have a 1976 F100 ford half ton. It has a Dana 44 front axle. I'm looking for inner axle axle shafts. The over all length for the passenger side inner shaft is 35". The inner driver side over all length is 19-3/4"  If u have some your willing to part with maybe we can make a deal.

[workgoats]

Well, if the 82 RC at the house has the same length axles you can have it.  All you would need to do is help me swap the one out of the red truck in its place.

[taz_man440]

I should have some in the shop, I'll look to be sure... if nothing else if you want to replace Rons...

[ernestgonzales78@gmail.com]

cool that works on both offers.

[rjtx667]

anyone have the metal bearing spacer that goes on the outside bearing? one of mine in the 93 is jacked up... think its what is causing my axle leak and I need to locate a replacement.

[taz_man440]

Ryan, I know I had some rotors out in the shop, will look & see if they are complete..

[workgoats]

anyone have the metal bearing spacer that goes on the outside bearing? one of mine in the 93 is jacked up... think its what is causing my axle leak and I need to locate a replacement.

We think that he is referring to the bearing race.  We have some good used ones but I doubt if that is the cause of a leak. 

[taz_man440]

Well, went & looked & I have no rotors left to get races from... I do however have 2 long side axlevshafts with stub shafts on them.. 1 short side cad shaft...  didn't measure em but they are available. ?.

[ernestgonzales78@gmail.com]

That's awesome!!! But I really need the length.  Please

[rjtx667]

not sure what I am looking for is a bearing race... here is a pic of the bad one.

[taz_man440]

Ryan, ill dig through the shop & see what i have left, i know i have a ziploc bag with the guts to automatic hubs... let ya know this evening....

[rjtx667]

yeah it could be something to do with the auto hubs... I have been considering getting manual ones for the trail rig, should probably break down and do that.

[taz_man440]

Have you tested to make sure the cad works? Might need to manually lock the cad & put manual hubs....

[rjtx667]

thrown it in 4H and it seemed to be pulling, but have not tested it on jack stands. I think its safer to just lock the cad and do the manual hubs, if I can find a pair reasonable priced.

[taz_man440]

Well, that way you are guaranteed to have a true 4 wheel drive...  I tend to keep the passenger side locked & just lock the driver side when needed, but then I haven't done a lot of highway driving with mine...