RamCharger.net

Would 89 3/4 Ton Van leaf springs and axle fit our trucks?

I have no clue, but I don't see why not. The only thing I can thing of is that the axle might not be as wide as the truck axles?

I thought it was basically a truck frame
   

Quote from: SixGun on April 28, 2015, 09:28:22 PM
I thought it was basically a truck frame
   

not really.... the rear axle will be a bit wider than a truck....not sure if the spring perches are in the same place either... you can use 2wd van lower control arms to lower your front 2-3 inches though 

sounds like someone needs a tape measure and a trip to the local pick n pull 

Quote from: rjtx667 on April 29, 2015, 09:24:02 AM
sounds like someone needs a tape measure and a trip to the local pick n pull 

I get figitty if I don't go. Its an addiction.   

Quote from: SixGun on April 29, 2015, 01:31:03 PM
I get figitty if I don't go. Its an addiction.   

you need to go soon... give me a call ... I am always in need of more junk... Eric needs more junk too 

You guys wanna go? I'm off Saturday. Classic section is open 9am -12pm on weekends. Some interesting stuff in there.

Quote from: SixGun on April 29, 2015, 09:49:52 PM
You guys wanna go? I'm off Saturday. Classic section is open 9am -12pm on weekends. Some interesting stuff in there.

no can do this weekend... going to montanna ... I will post some pics though.... the next weekend you have free we definitely need to go check out the bone yard 

Richard, if your bored and looking for stuff to do, you can come help pull a piston out of a cummins... maybe replace some struts in a Sebring.

I will have the smoker going again 

If only we were a little closer. 

Friday should be fun. I'm helping a buddy slam a built 360 into an old Valiant (I believe).

i think the axles and leafs from a van would work with a truck but i don't know if there would be much point swapping with one unless yours has gone bad. they use all the same brake parts. the 250 vans are pretty much just heavy half tons.